Pentair Clean and Clear Plus CCP520 Cartridge 520 sq. ft. In Ground Pool Filter

Clean & Clear Plus cartridge filter combines top-end filter performance with low maintenance. This dependable design uses special filter elements to strip tiny particles from your pool water... particles as small as 30 microns. (An average grain of beach sand is 1000 microns!) Our four-cartridge design provides maximum filter surface area to capture more dirt and extend time between cleaning. And cleaning is a snap. Open the top, remove the cartridges, hose them off, and Clean & Clear Plus is ready to go again. Clean & Clear Plus cartridge filters contain four polyester cartridges that hold enormous amounts of dirt, yet are easy to clean. The fiberglass-reinforced tank halves are secured with an innovative clamp ring - just loosen the ring and remove the top half for easy cartridge access and rinsing. Filter maintenance doesn't get any easier.

Key Features:

• NSF listed Superior strength Large filter area for increased dirt capacity

• 1-1/2 in., 100% drain clean-out port

• Continuous High Flow™ internal air relief*

• Base and plumbing kits now available

• Injection molded tank

• Balanced hydraulic flow

• Tension Control™ clamp

• 100% factory tested

• Black bulkhead unions

• High Flow manual air relief valve

Note: Actual system flow will depend on plumbing size and other system components.

Note: Pentair Pool Products does not recommend flow rates above 150 GPM

*Integrated Continuous High Flow internal air relief is operational only when there is unobstructed flow in the circulating system.
Operating Limits - maximum continual operating pressure of 50 PSI. Pool/spa (bather) applications, maximum operating water temperature (internal filter) 104 degrees F (40 degrees C)