ecoSAVER Solar Panel Kit, One Panel (20' x 30")

The Solar Panel kit will easily mount to your roof, allowing you to harness the natural heat from the sun and enjoy the advantages of using green technology to produce energy. The panels are made from a flexible rubber material that will create an effective heat transfer system, helping to efficiently generate energy. It works with your pool’s existing filtration system: water is heated by the sun by circulating through the solar panel, and returns to your pool afterwards through the existing fitting.

The Solar Panel kit will easily mount to your roof, allowing you to harness the natural heat from the sun and enjoy the advantages of using green technology to produce energy.

Highlights:

• Unique Modular Design

Makes it easy to install multiple panels together

• Expandable System

You can add additional panels at any time

• Flexible and Easy to Install

Made of LDPE material the ecoSAVER™ panels are durable and  resistant to pool chemicals

• Twist Connect Fittings

Installation is simple. With quick connect fittings, all you need is a screwdriver

• Optional Diverter Kit

Diverter valve lets water bypass panels

• Safe To Use

No gas lines, no fumes, no pollution

Additional Information:

Location of Eco Saver System:

• For best results the ecoSAVER solar heating system must be installed in an area that receives direct sunlight for at least 6 hour a day. This should be in the middle of the day when temperatures are the hottest

• The panels may be placed on the ground, on a rack, or on the roof of a building (i.e. shed, garage, or house). The panels should face SOUTH to capture the maximum amount of sunlight. Do not face panels away from the sun, such as on a north-facing roof

• If the panel(s) are installed on the ground, do not place in a high traffic area. Do not walk on the panels as it may damage them and it will void the warranty

• Make sure there are no sharp objects where the panels will lie. Sharp objects can damage the panels and cause leaks

• If the system is mounted on a rack, the rack should be placed at an incline of 30 – 45 º. The rack should not be located where a child can climb on it to gain access to the pool

• An optional Roof Mounting Kit is required for proper installation on a roof or rack

• With the proper pump size, the system may be located up to 30’ from the filter system and on the roof of a 1-story structure.

Pool Pump Size:

• The pump on the filter system should be a full rated pump of 1HP– 1 1/2 HP

• A pump less than 1 horsepower may need to be upgraded for sufficient water flow. After installation of the system and with the filter running, place your hand in the water in front of the inlet fitting. If you feel weak flow you may first try placing the panel(s) closer to the pool. Upgrade pump if needed

• If the pump is larger than 1 1/2 horsepower the optional Diverter Valve Kit (# ESDK-1) must be installed. Failure to control the amount of water flow with a Diverter valve may result in damage to the panel

Each kit comes with : 1 panel (30” x 20'), installation instructions, and a hardware and parts kit (1 female elbow fitting, 1 male elbow fitting w/ O-ring, 2 clamps, 2 hose adapters w/O-rings).